Saniflo COLORmaxx Series 013 3/4IN OR 1IN Pump Grinder, 9 A, 120 V
- An easy access service panel is located on top of the pump, this will give you easy access to the electrical components such as the capacitor, microswitch, electronic board and membrane
- Discharges the waste through a 3�4 or 1 in rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the system, this elbow can be rotated 360 deg depending on the discharge installation
- Has been designed with a 11�2 in vent connection on the top of the lid, all plumbing codes require connection to a vent system, please note that the vent system should be a two-way air vent as air needs to freely flow both ways
- Must be connected to Saniflo's 1.28 GPF rear discharge toilet, these toilets come in round and elongated (ADA compliant) models
- Will also discharge gray water from any sink, bath/shower, urinal and even a washing machine (indirect connection), the wastewater will drain into the system via two 2 in inlets with built-in check valves on either side of the housing, note that when adding a bathtub/shower, the base should be raised up by a minimum of 8 in off the floor
Description
Specifications
UNSPSC Code
40.405.405
Weight
27lb
Height
13.75in
Width
10.75in
Length
23.5in
Brand
SANIFLO
Category
PUMPS (NON-WELL)
Cord Length
49 in
Current Rating
9 A
Frequency Rating
60 Hz
Fuel Tank Capacity
3.2 gal
Temperature Rating
104 deg F
Voltage Rating
120 V